Pages

Saturday, 27 February 2010

Electronics inside the P6 project




This is just to show the electronics and power supply positions inside the Primary 6 project. There is one PSU, which is an old stly AT 200W supply stripped from a computer. This drives the servos inside the simkits instruments which is the long circuit board loacated on the right hand side . The one to the left is Leo Bodnar's 32 input controlle. It connects all of the switches. Obviously I haven't shown all of the cables and wires that will make all of this work. It's going to be quite busy inside this chassis. I am also wondering if i should put a 120mm exhaust fan to try and dissipate the heat that will be generated from the PSU. This will be wired up to the supply via a molex connector and will come to life as soon as i turn it on.

No comments:

Post a Comment